Pentax DS2 - Manual (Page 140)

138
5
F
uncti
on Re
ferenc
e
• Turn the e-dial while pressing the mc button and change the EV
Compensation value. (p.142)
• Set the aperture value in increments of 1/2 EV or 1/3 EV. Set in [Expsr Setting
Steps] in the [A Custom Setting] menu. (p.143)
• You can automatically correct the sensitivity if appropriate exposure cannot
be set with the set criteria. Set [Sensitivity] to [AUTO] in the Fn menu. (p.115)
• Set the aperture to the s position while
holding down the auto-lock button when
using a lens with an aperture ring.
Exposure Warning
If the subject is too bright or too dark,
the shutter speed will blink in the
viewfinder and on the LCD panel. If the
subject is too bright, set the aperture
smaller (larger number), and when too dark, open the aperture further
(smaller number). Once blinking stops, you can take the picture.
If both the shutter speed and aperture value are blinking, this
indicates being out of metering range and the proper exposure
cannot be obtained even if the aperture is adjusted.
Use an ND (Neutral Density) filter if the subject is too bright.
Use a flash if it is too dark.