Porter-Cable BN200V12 - Manual (Page 6)

6
7. Check for misalignment or binding of moving parts, breakage of
parts, and any other condition that may affect the tool’s operation. If
damaged, have the tool serviced before using. Many accidents are caused
by poorly maintained tools.
8.
Use only accessories that are recommended by the manufacturer
for your model. Accessories that may be suitable for one tool may create a
risk of injury when used on another tool.
SERVICE
1. Tool service must be performed only by qualified repair personnel.
Service or maintenance performed by unqualified personnel may result in a
risk of injury.
2.
When servicing a tool, use only identical replacement parts. Follow
instructions in the Maintenance Section of this manual. Use of
unauthorized parts or failure to follow Maintenance Instructions may create a
risk of shock or injury.
SPECIFIC SAFETY RULES AND SYMBOLS
1. Be aware that this tool is always in an operating condition, because it
does not have to be plugged into an electrical outlet. Always set the switch to
the OFF position when installing or removing the battery pack or nails.
2.
Never hold work in your hand, lap, or against other parts of your body
when nailing.
3.
Some wood contains preservatives which can be toxic. Take extra
care to prevent inhalation and skin contact when working with these materials.
Request, and follow, all safety information available from your material
supplier.
SYMBOL DEFINITION
V .......................... volts
A .......................... amperes
Hz .......................... hertz
W .......................... watts
PSI .......................... pounds per square inch
Min. .......................... minimum
Max. .......................... maximum
in. .......................... inch
MM .......................... millimeters
h .......................... hours
min .......................... minutes
s .......................... seconds
.......................... alternating current
.......................... direct current
n
0
.......................... no load
.......................... alternating or direct current
.......................... Class II Construction
…/min .......................... revolutions or reciprocation per minute
SAFETY INSTRUCTIONS FOR CHARGER AND BATTERIES
1. SAVE THESE INSTRUCTIONS. This manual contains important safety
and operating instructions for Porter-Cable Battery Charger.
901891 - 08-31-01.qxd 2/13/02 11:52 AM Page 6