Porter-Cable BN200V12 - Manual (Page 10)

OPERATION
USING THE TOOL
Complete all steps of PREPARING THE TOOL before using the tool.
To fasten, move switch (A) Fig. 19 to desired position, grip tool firmly,
position nose of tool onto work surface, push forward on tool to depress
safety, and squeeze trigger to fire a fastener while allowing tool to recoil.
WARNING: Remove finger from trigger when not driving fasteners.
Never carry tool with finger on trigger: tool may fire a fastener if
safety is bumped.
WARNING: Keep tool pointed in a safe direction at all times.
WARNING: Never attempt to drive a fastener into material that is too
hard, or at too steep an angle, or near the edge of the workpiece.
The fastener can ricochet causing personal injury.
10
Fig. 16
Fig. 17
←
→
Fig. 14A
Fig. 15
Fig. 18
A
Fig. 14
A
B
A
B
C
←
901891 - 08-31-01.qxd 2/13/02 11:52 AM Page 10