beautypg.com

Troubleshooting, Warning – Philips AZ 6188 User Manual

Page 21

background image

21

English

TROUBLESHOOTING

Problem

Solution

"

NO DISC" is displayed

Insert a disc and check if the disc is upside down.
Wait until the moisture condensation at the lens has

cleared.

Replace or clean the disc, see "Maintenance"
Use a readable disc or an MP3-CD recorded in the

correct format.

Radio reception is poor

If the signal is too weak, adjust the antenna for better

reception.

Increase the distance between the Receiver and your

TV or VCR.

Recording or playback cannot be made Clean deck parts, see "Maintenance".

Use only NORMAL (IEC I) tape.
Apply a piece of adhesive tape over the missing tab

space.

The system does not react when the

Slide the source selector to TAPE/OFF. Remove the

buttons are pressed /The set does not

AC power plug and reconnect it 30 seconds later

work / No display on LCD.

and then switch on the system again.

Sound cannot be heard or is of poor

Adjust the volume.

quality

Make sure the MP3-CD was recorded within 32-320

kbps (128kbps preferably) with sampling frequencies
at 8 - 48 kHz (44.1kHz preferably).

Loop, Follow or Compare is not available Check if the language learning mode is activated. Press

and hold MODE until LANG ON appears on the
display.Then the language learning is activated.

The set does not break sentences

The CD disc may be scraped. Please replace the disc

automatically

with a new one.

If in the tape mode, the tape quality may be poor.

Please use a good tape.

The playing speed cannot be changed

The playing speed can be changed only in the

language learning mode.

Please activate Loop, Follow or Compare function in

the language learning mode first.

If a fault occurs, first check the points listed below before taking the set for repair. If you are unable
to remedy a problem by following these hints, consult your dealer or service centre.

WARNING:

Do not open the set as there is a risk of electric shock. Under no
circumstances should you try to repair the set yourself, as this will
invalidate the guarantee.

AZ6188_01_Eng(NEW) 4/22/04 16:52 Page 21