Panasonic SC-EN25 - Manual (Page 4)

4
SLEEP
CLOCK/
TIMER ADJ
DISPLAY
TIMER
SET/CHECK
PGM/CLEAR
-AUTO PRESET
OPEN/
CLOSE
1 2 3
4 5 6
7 8
0
9
> = 10
MUSIC PORT
TUNER/
BAND
CD
SOUND
EQ
LIVE
VIRTUALIZER
PLAY
MODE
ALBUM
VOL VOL SC-EN25/SC-EN26 SC-EN27
PRESET TUNE u ALBUM i
TUNER/
BAND u i
3 4
TUNER/
BAND u i
3 4
TUNER/
BAND
1 2 3
4 5 6
7 8
0
9
> = 10
Within 10 seconds
PGM PGM
SC-EN25/SC-EN26 SC-EN27
MONO MONO
Radio operations
Radio stations can be tuned manually by selecting the station’s frequency or they can be preset into channels to make it easy to tune.
You can preset up to 20 FM channels and up to 12 AM channels.
To adjust the volume
0
(Minimum)
50
(Maximum)
Input using the numbered
buttons
To select a 2-digit number
e.g. 11: [ 10] → [1] → [1]
To adjust the volume
Allocation settings
Each country allocates broadcast bands according to their particular system.
You can change the FM step. The step is factory-set to 0.2 MHz, but you
can change it to receive broadcasts allocated 0.1-MHz steps.
Any FM frequencies preset in channels will be changed by this procedure.
Preset them again.
1. Select the AM band with [TUNER/BAND].
2. Press and hold [TUNER/BAND] on the unit.
After a few seconds the display changes to show the current minimum
frequency. Continue to hold the button down. The minimum frequency
changes and the step is changed.
To return to the original step, repeat the above steps.
Note
The preset memory will be initialized when you change the frequency step.
To improve reception
FM AM
Receive the radio stations after
connecting the antenna. Then
attach the antenna code on the wall
or pillar in the good reception.
Change the direction and location
of the antenna.
If noise is excessive in FM
You can improve FM reception by switching reception to monaural.
Press to turn the MONO
mode ON/OFF
Manual
tuning
Main unit
Remote control
Select “FM” or “AM” Select the frequency
Select “FM” or “AM” Select the frequency
Automatic
presetting
The tuner
presets the
stations it can
receive into
channels in
ascending order.
Auto
tuning
Manual
presetting
Preset the
stations one at a
time.
Selecting
channels
Main unit
Remote control
Select “FM” or “AM” Press and hold until the
frequency starts changing
rapidly
Select “FM” or “AM” Press and hold until the
frequency starts changing
rapidly
• Auto tuning stops when it fi nds a station.
• To cancel auto tuning press the same button again.
• Auto tuning may not function when there is
excessive interference.
Note
Perform once for FM stations and once for AM stations.
Select “FM” or “AM” Press and hold until
“AUTO” appears
During automatic presetting, the memory indicator
( PGM ) fl ashes and the frequency scrolls. The memory
indicator and channel numbers are displayed for a
second when a station is preset.
The fi rst station to be preset is displayed when
presetting fi nishes.
Note
Tune to the
signal you
want to
set as the
preset.
Enter preset mode
Select a channel
The station occupying a channel is erased if another
station is preset over that channel.
Note
Select “FM” or “AM” Select a channel
Select “FM” or “AM” Select a channel