beautypg.com

2 rear panel, 3 hardware installation, Anel – Planet Technology FNSW-1608PS User Manual

Page 9: Ardware, Nstallation

background image

- 9 -

2.2 Rear Panel

The rear panel of the Web Smart PoE Switch indicates an AC inlet power socket, which accepts input power from 100 to
240VAC, 50-60Hz, 1A.

100~240V AC

50 / 60Hz

Figure 2-3: FNSW-1608PS / FGSW-1828PS Switch rear panel

Power Notice:

1. The device is a power-required device, it means, it will not work till it is powered. If your networks should active all the

time, please consider using UPS (Uninterrupted Power Supply) for your device. It will prevent you from network data
loss or network downtime.

2.

In some area, installing a surge suppression device may also help to protect your Web Smart PoE Switch from being

damaged by unregulated surge or current to Web Smart PoE Switch.

2.3 Hardware Installation

This part describes how to install your Web Smart PoE Switch and make connections to the Switch. Please read the fol-
lowing topics and perform the procedures in the order being presented. To install your Web Smart PoE Switch on a desktop
or shelf, simply completed the following steps.

2.3.1 Desktop Installation

To install Web Smart PoE Switch on a desktop or shelf, simply completed the following steps:

Step 1: Attached the rubber feet to the recessed areas on the bottom of the Web Smart PoE Switch.

Step 2: Place the Web Smart PoE Switch on a desktop or shelf near an AC power source.

Step 3: Keep enough ventilation space between the Web Smart PoE Switch and the surrounding objects.

#

Notice:

When choosing a location, please keep in mind the environmental restrictions discussed in
Chapter 1, Section 4, Specification.

Step 4: Connect your Switch to network devices.

A. Connect one end of a standard network cable to the 10/100 RJ-45 ports on the front of the Web Smart PoE Switch.
B.

Connect the other end of the cable to the network devices such as printer servers, workstations or routers…etc.

#

Notice:

Connection to the Web Smart PoE Switch requires UTP Category 5 network cabling with RJ-45
tips. For more information, please see the Cabling Specification in Appendix A.

Step 5: Supply power to the Web Smart PoE Switch.

A.

Connect one end of the power cable to the Web Smart PoE Switch.

B.

Connect the power plug of the power cable to a standard wall outlet then power on the Web Smart PoE Switch.

When the Web Smart PoE Switch receives power, the Power LED should remain solid Green.

This manual is related to the following products: