Premier Mounts USA - Manual (Page 6)

USA
Page - 6 - Installation Instructions
Support Tube Installation
NOTE: Please refer to the base installation instructions for the assembly of the base and the support tubes. The support tubes and
base must already be assembled.
NOTE: If the optional shelf has been purchased, the shelf must be attached prior to attaching the USA bracket arms. Please refer to
the shelf installation instructions. When working with the shelf, take precautions not to scratch it.
1. Slide one of the USA bracket arms over and down the support tubes. This will be the lower bracket arm.
NOTE: The USA lower mounting bracket can rest on the optional shelf, or base, prior to upper bracket installation.
Attaching the Upper USA Mounting Bracket
1. Place the display on a soft, flat surface. Locate the mounting points that are located on the back of the display.
2. Once the mounting points are located, place the upper USA bracket arm over the mounting points.
3. Center the mounting bracket arm on the back of the display.
NOTE: Please refer to ‘Thread Depth Indicator Use’ on Page 5 to determine the correct hardware.
4. Once the desired position has been determined, place the griplates over each mounting point (flat side down) and secure them
using the appropriate hardware (see Page 4). If nylon spacers are needed, place the spacer over the mounting point, between the
display and the USA mounting bracket, insert the appropriate hardware and tighten the screw.
5. At this time, center the USA mounting bracket on the display and tighten the mounting screws.
USA Upper Mounting Bracket Nipples Facing Up
Griplate™
M4 M5 M6 M8
Display
Mounting Point Mounting Point
Support Tubes
USA Bracket Arm
USA Bracket Arm