beautypg.com

Radio reception – Philips AQ 6688 User Manual

Page 7

background image

TUNING
Direct Access tuning
The frequency of the station you wish to tune to must be
known. You can find these frequencies in station tables or
radio guides.
1 In the radio mode, press ENTER.

™ The current frequency in the display disappears.

2 Use the Preset memory buttons to enter the digits of your

desired frequency within a 5 second period.

3 Press ENTER again to confirm your radio station.

™ The display shows the selected frequency or the nearest

frequency.

™ If you have made an incorrect entry, Err will appear in

the display.

Entry examples of bands and frequencies:
e.g.i

98.1 MHz, FM: Press 9,8,1 and ENTER

e.g.ii

603 KHz, AM (MW): Press 6,0,3 and ENTER

Manual tuning
Press TUNING – or + briefly, once or as often as required

until the right frequency is found. In this way, the frequency
can be changed step by step.

Automatic tuning
1
Press and hold down the TUNING – or + control until the

display frequency starts to run.

2 When a station of sufficient strength has been found, tuning

will stop, or you can stop the automatic tuning by pressing
the TUNING – or + control again.

3 Repeat until you have found the desired station.

SELECTING & STORING FREQUENCIES: PRESETS
You can store the frequencies of 20 radio stations in the
memory, 10 on each waveband. A stored frequency is only
erased from the memory by storing another frequency in its
place, or if you reset your unit.
1 Select the waveband and tune to your desired station.
2 Select and press one of the Preset memory buttons 0-9 for

more than two seconds to store your station.
PRESET and your selected number will appear in the display.

7

AQ 6688 /00 - page 7

RADIO RECEPTION

English