beautypg.com

Using the remote control, Installing the unit, Plugging in – Pioneer XW-NAS5 User Manual

Page 7: Before you start 01

background image

Before you start

01

7

En

English

Français

Deutsch

Nederlands

Italiano

Español

• Remove the battery if the unit isn’t going to

be used for a month or more.

• When disposing of used batteries, please

comply with governmental regulations or
environmental public instruction’s rules
that apply in your country or area.

WARNING
Do not use or store batteries in direct
sunlight or other excessively hot place,
such as inside a car or near a heater. This
can cause batteries to leak, overheat,
explode or catch fire. It can also reduce the
life or performance of batteries.

“ Perchlorate Material – special handling may apply.
See www.dtsc.ca.gov/hazardouswaste/perchlorate.
(Applicable to California, U.S.A.) “

Using the remote control

The remote has a range of about 7 m (23 ft.) at
an angle of about 30º from the remote sensor.

Keep in mind the following when using the
remote control:

• Make sure that there are no obstacles

between the remote and the remote sensor
on the unit.

• Remote operation may become unreliable

if strong sunlight or fluorescent light is
shining on the unit’s remote sensor.

• Remote controllers for different devices

can interfere with each other. Avoid using
remotes for other equipment located close
to this unit.

• Replace the batteries when you notice a fall

off in the operating range of the remote.

Installing the unit

• When installing this unit, make sure to put

it on a level and stable surface.

Don’t install it on the following places:
– on a color TV (the screen may distort)
– near a cassette deck (or close to a device that
gives off a magnetic field). This may interfere
with the sound.
– in direct sunlight
– in damp or wet areas
– in extremely hot or cold areas
– in places where there is vibration or other
movement
– in places that are very dusty
– in places that have hot fumes or oils (such as
a kitchen)

Plugging in

After you’ve finished making all connections,
plug the unit into an AC outlet.

1

Plug the supplied power cord into the AC

IN socket on the back of the unit.

2

Plug the other end into a power outlet.

Important

• Before making or changing any

connections, switch off the power and
disconnect the power cord from the AC
outlet.

30°

30°

7 m (23 ft.)

AUDIO IN

AC IN

FM UNBAL 75

ANTENNA

XW-NAS5_CUXJ.book 7 ページ 2010年1月26日 火曜日 午後5時0分