Pioneer XW-NAS5 - Manual (Page 21)

Using the timer 08
21
En
English
Français
Deutsch
Nederlands
Italiano
Español
Chapter 8:
Using the timer
Setting the clock
Setting the clock allows you to use the timer.
1
1 Switch the unit into standby.
2 Press SETUP.
3 Use / to select ‘ ’, then press
ENTER.
The current time is displayed.
4 Use / to set the hour, then press
ENTER.
5 Use / to set the minute, then press
ENTER.
When the setting is completed, the newly set
value flashes for 3 seconds, then the power
returns to standby mode.
Display mode setting
Use to switch the display mode (clock display,
etc.)
1 With the power turned ON, press SETUP.
2 Use / to select ‘ ’, then press
ENTER.
The current time is displayed.
3 Use / to select display setting, then
press ENTER.
• – Display is turned off except when
entering commands. 2
• – Clock display appears except
when entering commands.
• – Displays values constantly except
when entering commands. When power is
on standby mode, displays clock.
2
Changing the clock’s display mode
You can choose to display the clock in 12-hour
mode or 24-hour mode.
• Default setting: (24-hour mode)
1 Switch the unit into standby.
2 Press SETUP.
3 Use / to select ‘ ’ then press
ENTER.
4 Use / to select ‘ ’ or ‘ ’ then
press ENTER.
When the setting is completed, the newly set
value flashes for 3 seconds, then the power
returns to standby mode.
Setting the wake-up timer
Use the wake-up timer to set the unit to switch
on at any time and start playing whatever
source you want.
If iPod is selected as the timer sound, when the
wake-up timer operates, the iPod’s power will
automatically turn ON and playback will begin.
Note
1 You’ll need to set the clock again if you unplug the unit (or in case of a power failure).
PRESET PRESET
ENTER
SLEEP
CLOCK SETUP
WAKE
UP
TUNER
PRESET
BASS/
TREBLE
TUNE
TUNE
2 When power is ON or in standby mode, the current time can be checked by pressing the CLOCK button.
XW-NAS5_CUXJ.book 21 ページ ２０１０年１月２６日 火曜日 午後５時０分