Pioneer XW-NAS5 - Manual (Page 12)

iPod playback 03
12
En
4 Use / to select the video output
setting.
• – The video output will switch to
Composite.
• – The video output will switch to
Component.
5 Press ENTER.
The setting will be completed, and the display
for the newly set value will flash for three
seconds, after which the power will once again
switch to standby mode.
Playing your iPod
Caution
• When your iPod is connected to this unit
and you wish to operate the iPod by
touching it directly, be sure to hold the iPod
steady with the other hand to prevent
malfunctions due to faulty contacts.
When an iPod is connected to this unit,
will flash while the unit confirms the iPod
connection and retrieves data from the iPod.
When
INPUT is pressed to change the input to
iPod, the connection is completed and
will light steadily.
1
Playback and volume level setting for iPod
music and images can be performed from this
unit or the iPod itself.
• When using the iPod to adjust sound
volume, the adjustment will be applied only
to the sound produced from this unit’s
speakers.
2 If the iPod is disconnected from
this unit, the iPod’s sound volume will
return to its original setting.
The following operations are possible for iPod,
using the remote control.
Using the tone controls
Adjust the sound tone. Adjustment is
performed from the iPod’s screen.
2
The
settings performed here are reflected in the
BASS/TREBLE settings on this unit.
iPod nano or iPod classic:
1 Select ‘Speaker’ from the top menu.
2 Select ‘Tone control’.
3 Select a setting.
iPod touch or iPhone 3 :
1 Select ‘Settings’ from the home menu.
2 Select ‘Speaker’.
3 Select ‘Tone control’.
4 Select a setting.
Select one of the following:
• Flat – Revert sound to its natural state.
• Bass ON – Emphasize bass sound.
• Treble ON – Emphasize treble sound.
• Bass/Treble ON – Emphasizes bass and
treble sounds.
Note
1 If an iPod is connected when this unit is in standby mode, the power will turn on and iPod input will be selected automatically.
2 These adjustments are applied to all inputs to the unit.
Button What it does
/ Starts normal playback and pauses/
unpauses playback.
 Press to skip to the start of the current
file, then previous files. Press and hold
to start fast reverse scanning.
 Press to skip to the next file. Press and
hold to start fast forward scanning.
VOLUME
+/– Use to set the listening volume.
3 This setting may not be supported, depending on the iPod touch or iPhone software version.
XW-NAS5_CUXJ.book 12 ページ ２０１０年１月２６日 火曜日 午後５時０分