Panasonic PT-AE4000U - Manual (Page 11)

E NGLISH - 11
Preparation
About Your Projector
Remote control
Power button
While MAIN POWER is on,
switch between standby
mode and projection mode.
Button backlight
When any button is pressed, the button
backlight is lit. Without any operation, it
gets darker after 5 seconds and goes
off after next 5 seconds. Remote control signal emitter
Emit remote control signal.
Display the PICTURE menu
or ADVANCED MENU.
Switch to cycle through the
PICTURE MODE.
Display the VIERA LINK
menu.
Display the main menu or
return to the previous menu.
Navigate through the
menus with ▼ ◄ ►,
and activate the menu
item with the ENTER
button.
Open the connected
equipment menu while using
the VIERA Link.
Switch to cycle through
the input method.
Display the ZOOM/FOCUS
menu.
Display the MEMORY LOAD
menu.
Capture the projected image
as a still image.
Display the input waveform.
Reset some of the settings
to the factory default.
Return to the previous menu.
Activate the assigned
function from the menu
options for shortcut.
Battery compartment
Press the tab and lift up the cover. 1.
Insert the batteries according to the polarity diagram indicated 2.
inside.
Note:
See the functional instructions that is in the provided CD-ROM for more details. •
Do not drop the remote control. •
Avoid contact with liquids or moisture. •
Use manganese batteries or alkaline batteries with the remote control. •
Do not attempt to modify or disassemble the remote control. Contact an Authorized Service Center for repairs. •
Do not keep pressing the remote control buttons as this may shorten battery life. •
Preparation