Pride Mobility Cantilever Lift System - Manual (Page 10)

10 Basic Operation Instructions
Cantilever Lift System www.quantumrehab.com RevA/Nov03
SPEED
SETTING
INDICATOR
ACTUATOR
INDICATOR
MODE
KEY
Figure 4. Remote Plus Controller
CANTILEVER LIFT OPERATION - REMOTE PLUS
To operate the cantilever lift:
1. Bring your power chair to a complete stop.
2. Press the mode key until the actuator indicator lights up. See figure 4.
3. Push the joystick forward to raise the lift. Pull the joystick back to lower the
lift. Once the lift reaches its highest extension and the lift action stops, you
should continue to hear and/or feel the lift motor running. This is because there
is a clutch mechanism that allows the motor to continue running after the lift
has reached its limit. This clutch works at both the top and bottom extensions
of the lift. When you release the joystick, the lift motor will stop.
NOTE: Do not allow the motor to run more than a few seconds after
the mechanism reaches the top or bottom limit.
4. Press the mode key again until the speed setting indicator lights up.