beautypg.com

PVI Industries PV500-44U User Manual

Page 33

background image

33

PV500-44U 06/12

 

15 TROUBLESHOOTING

GUIDE


Problem

Probable Cause

Corrective Action

Starting or Pre-purge

Failure

Power Supply

Check fuse and/or circuit breaker. Check voltage at
120/24V step-down transformer.

On-Off Switch

Check if On-Off switch is lighted.

Temperature Control

Check that the operating temperature control is set
higher than the temperature of the water heater.

Flame Safeguard Control

Check for bad ground or bad control. Replace if
necessary.

Remote enable/disable open

Enable water heater or place jumper between
terminals R1-R2.

Combustion Air blower

Check if fan connection terminals on flame control
is closed.
Check for 24V at field access terminal C2. Remote
interlock may be open.
Fan VFD may be defective. Verify proper voltage.

Air-proving Switch

Check switch contacts are closed.
Check for 24V at the N.O. side of air switch.
Check for 24V at the common side of air switch.
Check for proper blower pressure setting – adjust if
required. Air switch may be defective.

Blocked Filter Switch

(if equipped)

Check for 24V at the N.C. side of the blocked filter
switch. Replace filter or switch as required.

Flame Control Pressure Switch

Check for 24V at the pressure switch terminal.

Loose Wire Connections

Check connections to all components.

Flame Failure

Power Supply

Check fuse and/or circuit breaker. Check voltage at
120/24V step-down transformer.

Flame Safeguard Control

Check for bad ground or bad control. Replace if
necessary.

Hot Surface Igniter

Check amp draw during heat-up. Replace if amps
greater than 3.1A. Check for overheating condition
due to damaged refractory around igniter.

Air-proving Switch

Check if switch is bouncing. Adjust or replace.

Gas Pressure

Check for proper inlet static and dynamic gas
pressure.

Combustion

Inadequate flame signal may result from improper
combustion. Adjust to proper CO2 levels at low fire.

Grounding

Check for proper ground from flame control to
burner housing.

Safety Limits

Check all safety limits for fault condition and correct
as required.