Philips MT3120 - Manual (Page 9)

7 EN
Note
•
During normal use, it is not necessary to switch off the
phone at any time. Switch the phone off only during
extended period of non-use. In this case, time and date
settings will be lost.
Configure your phone
(country dependent)
When using your phone for the first time it will
prompt you for initial setup information.
Set the country/language
Select your country/language, then tap to
confirm.
» The country/language setting is saved.
Note
• The country/language setting option is country
dependent. If no welcome message is displayed, it
means the country/language setting is preset for your
country. Then you can set the date and time.
•
You can re-set the language later (see 'Set the display
language' on page 18).
Register your phone
Your phone automatically asks you to register
the phone with your original cordless phone's
base station when you turn it on for the first
time. If you skipped this step, refer to steps 1-3
below, otherwise continue after step 3.
1
Tap to access the main menu screen.
2
Select > [Services] > [Register], then
tap to confirm.
3
Press the paging button on your original
cordless phone's base station for
approximately 10 seconds to set the base
station of your phone to registration mode.
Note
•
Check in the user manual of your base station on how
to enter the registration mode. For most base stations,
this can be achieved by pressing the paging button for
5-10 seconds until you hear a confirmation signal.
• The phone tries to connect to the base station with a
series of standard passcodes automatically.
• A successful registration is indicated by a sound signal in
less than 30 seconds.
• If your base station uses the passcodes/PIN different
from the most common settings (e.g. 3456), you have
to enter this PIN/passcode manually by following steps
4 to 6.
• If you use a pin code with more than 4 digits, it cannot
be entered through the handsfree phone. In this case,
change your base stations pin code to a 4-digit pin code
(e.g.0000) and then resume the registration process.
4
If your base station's passcode/PIN is not
auto-recognized, enter the base station's
passcode/PIN.
5
Select to make corrections.
6
Tap to confirm the passcodes/PIN.
» When you see a confirmation message,
registration is complete.