Philips MT3120 - Manual (Page 21)

19 EN
Alarm
Your phone has a built-in alarm clock.
Set the alarm
1
Tap to access the main menu screen.
2
Select > [Alarm], then tap to confirm.
3
Select [On/off] > [On], then tap to
confirm.
4
Select [Alarm time], then tap to
confirm.
5
Tap / once or several times to enter
an alarm time, then tap to confirm.
6
Select [Repetition], then tap to confirm.
7
Select an alarm occurrence, then tap to
confirm.
8
Select [Alarm tone], then tap .
9
Select a tone from options, then tap to
confirm.
» The alarm is set and is displayed on
the screen.
Tip
•
Tap / to switch between [AM]/[PM] .
Note
• The alarm clock rings at the preset time every day until
it is set to [Off].
Turn off the alarm
When the alarm rings
Press any key to turn off the alarm.
Before the alarm rings
1
Tap to access the main menu screen.
2
Select > [Alarm] > tap to confirm.
3
Select [On/off] > [Off], then tap to
confirm.
» The setting is saved.
Services
Call list type
You can set if you can see all calls or missed
calls from the call log.
Set the call list type
1
Tap to access the main menu screen.
2
Select > [Services] > [Call list type],
then tap to confirm.
3
Select an option, then tap to confirm.
ECO mode
The handsfree phone supports Eco mode to
minimize transmission power and radiation.
1
Tap to access the main menu screen.
2
Select >[Services]> [Eco mode], then
tap to confirm.
You can choose between two modes:
• [Off]: No reduction of transmission power.
• [On]:
• In Eco mode, transmission will be
reduced to minimize radiation. For
selected Philips models (CD48x,
CD49x, CD68x, CD69x and SE888),
both the handset and DECT base will
reduce transmission power drastically
when the handset is close to the base.
The transmission power increases
automatically only when the handset
is further away from the base. Make
sure that Eco mode is also enabled
for these models when selecting Eco
mode on your handsfree phone. In this
mode, the range will be reduced by
approximately 50%.
• If you register your handsfree phone
with another phone base not listed
above, the handsfree phone will reduce
transmission power automatically when
it is close to the base. The DECT base