PVI Industries PV500-12 - Manual (Page 17)

TURBOPOWER 99

WATER HEATER
PV500-12 08/12 17
11.5 To View the Setpoint
 Push and release the SET key to see the set point value.
 To return to normal display, press SET + UP or wait 15 seconds without pressing any key.
11.6 To Change the Setpoint
 Push
the SET key. The upper display will show the “St1” parameter name, while the lower display will show
its value.
 Use
the UP or DOWN key to cycle through the parameter names.
 Push
the SET key to modify a parameter value. The value starts flashing in the lower display.
 To change it push the UP or DOWN keys. Push the SET key again to confirm the value and pass to the
setting of next set point.
 Repeat the operations described at points 3, 4, 5.
 To Exit: press SET + UP or wait 15 seconds without pressing any key.
NOTE: Each point has a time out of 15 seconds. If any key is pushed within 15 seconds the controller exits the
set points programming procedure.
NOTE: The set value is stored even when the procedure is exited by waiting the time-out to expire.
11.7 To Change Other Parameters
 Push
the SET and DOWN arrow simultaneously for 3 seconds.
 Select the required parameter. The name of the parameter is on the upper display; its value is on the lower
display.
 Press
the SET key: the value of the parameter will start blinking.
 Use
UP or DOWN to change the value.
 Press
SET to store the new value and move to the following parameter.
 To Exit: Press SET + UP or wait 15s without pressing a key.