ProForm Fusion PFSY6806.0 - Manual (Page 7)

7
5. Attach a Weight Guide (13) to the Base (1) with
an M10 x 50mm Bolt (96), two M10 Washers
(105), a 16mm x 6mm Spacer (11), and an M10
Nylon Locknut (108).
Attach the other Weight Guide (13) to the
Base (1) in the same manner.
Slide two Weight Bumpers (29) onto the Weight
Guides (13). Slide eleven Weights (27) onto the
Weight Guides.
See the inset drawing. Attach a 3 1/2" Pulley (43),
a Cable Trap (47), and two Half Guards (48) to
the second hole from the top of the Weight Tube
(16) with an M10 x 50mm Bolt (96) and an M10
Nylon Locknut (108).
Do not tighten the Nylon
Locknut yet.
Insert the Weight Tube (16) into the center hole in
the twelfth Weight (27). Tap the Roll Pin (79) into
the top hole in the Weight Tube.
Make sure that
the Pin is underneath the Weight and is cen-
tered in the Weight Tube.
Slide the Weight (27) onto the Weight Guides (13).
6. Note: If the Press Arm Cable (not shown) has
been routed through the Top Cover (24), make
sure that the Cable crosses under the Top
Frame (12) and hangs between the Weight
Guides (13) while this step is completed.
Attach the Top Frame (12) to the Weight Guides
(13) with two M10 x 65mm Bolts (95), four M10
Washers (105), two 16mm x 12mm Spacers (81),
and two M10 Nylon Locknuts (108).
Do not tight-
en the Nylon Locknuts.
Attach the Top Frame (12) to the Upright (3) with
two M10 x 100mm Button Bolts (91) and an M10
Nylon Locknut (108).
Set the Top Cover (24) over the Top Frame (12).
Tighten the M10 Nylon Locknuts (108) used in
steps 3 and 6.
16
79
13
13
5
27
27
29
96
11
1
105
105
108
Pin
Hole
12
95
105
108
6
3
81
108
105
13
13
24
91
16
96
48
48
47
43
108