Philips BDP5150/F7 - Manual (Page 38)

38
LIST OF SETTINGS
EN
Category Menus / Options Description
Adv
a
nced Setup
Video
Output HDMI Video HDMI 1080p/24
• This feature is available
only when the display
device is connected by
an HDMI cable.
• Refer to page 43 for
more information.
Auto “Auto”:
Outputs the picture in 1080p/24
(1080 progressive with 24 frames per
second) when it meets all the
conditions listed below:
• The video resolution and the frame
rate of the material is 1080p/24 .
• “HDMI Video Resolution” setting is
set to “1080p”.
• The display device supports the
1080p/24 output.
“Off”:
• Outputs the picture in 60p.
(60 frames per second, progressive)
Off
HDMI Video Resolution*
• This feature is available
only when the display
device is connected by
an HDMI cable.
• Refer to page 43 for
more information.
Auto Sets the resolution of the video signal
being output from the HDMI OUT jack.
• The selected resolution must also be
supported by your TV monitor.
480p
720p
1080i
1080p
HDMI Deep Color
• This feature is available
only when the display
device is connected by
an HDMI cable, and
when it supports Deep
Color feature.
Auto Reduces the posterization effect of
the playback picture.
“Auto”:
Reduces the posterization effect by
automatically outputting the 12 bit
color whenever the unit recognizes
the connected display device
supports Deep Color feature.
“Off”:
Outputs the standard 8 bit color.
Off
Component Output 480i Sets the resolution for the component
output picture.
• The selected resolution must also be
supported by your TV monitor.
• Refer also to your TV’s manual.
• If you have selected the resolution
not supported by your TV by mistake
and the picture gets disturbed, press
and hold [B (play)] on the front
panel for 5 seconds to change the
setting back to its default.
• When HDMI cable is connected, only
“480i” and the resolution selected in
the “HDMI Video Resolution” will be
available.
480p
720p
1080i With regard to the
DVD-video with a copy
protection, the resolution
will be set to 480p
regardless of the setting
here.
If 480p output is not
available, 480i will be
output.
De-interlacing Mode Auto “Auto”:
Automatically detects the film or the
video content, and appropriately
converts it.
“Video”:
Selects when the picture is distorted
when using “Auto”.
Video
Black Level On Adjust the brightness to compensate
for ambient room light.
Off
HD Noise Reduction On Reduces the noise of the playback
picture.
“On”:
Activates the Noise Reduction.
“Off”:
Deactivates the Noise Reduction.
Off