Philips FW585C - Manual (Page 14)

14
English
Switching the system ON
• Press CD, TUNER, TAPE or AUX.
You can also switch on the system by
pressing any one of the CD DIRECT PLAY
buttons.
Switching the system to
standby mode
• Press STANDBY ON again or B on the
remote control.
™ The system will switch to standby
mode.
™ About 5 seconds later, the system
will go into an energy saving mode
( < 2 watts ). The low power
STANDBY ON LED will be lit.
Selecting the Source
• Press the respective source selection
button: CD, TUNER, TAPE or AUX.
™ The display indicates the selected
source.
Note:
– For an external source, make sure you
have connected the audio left and right
OUT terminals of the external
equipment (TV, VCR, Laser Disc player,
DVD player or CD Recorder) to the AUX/
CDR IN terminals.
Important:
Before you operate the system,
complete the preparation procedures.
Demonstration mode
The system has a demonstration mode that
shows the various features offered by the
system.
When the system is switched
on for the first time, the demonstration
mode will start automatically.
Notes:
– During the demonstration, if you press
any source (or standby-on) button, the
system will switch to the respective
mode (or standby).
– When the system is switched to standby
mode, the demonstration will resume
five seconds later.
To stop the demonstration mode
• Press and hold STOP•CLEAR Ç
(on
the system only) for five seconds when
the system is in demonstration mode.
™ The demonstration will stop.
™ "DEMO OFF" is displayed.
™ The system will switch to standby
mode.
™ About 5 seconds later, the system
will go into an energy saving mode
( < 2 watts ). The low power
STANDBY ON LED will be lit.
Note:
– Even though the AC power cord is
removed from and reconnected to the
wall socket, the demonstration will
remain off until it is switched on again.
OPERATING THE SYSTEM
DIGITAL
SOUND CONTROL
FM
STEREO BACK HSD REC LW MW AM T.A. NEWS
SOUND NAVIGATION
DYNAMIC BASS
BOOST
TAPE CD
PROG
CLOCK/
TIMER
DOLBY B
NR
DUB
(HSD)
REC
SIDE A•B
TUNER AUX
PRESET ▲ ▲
STOP•CLEAR SEARCH • TUNING PLAY PAUSE PREV NEXT
MINI HIFI SYSTEM
C D 1 • 2 • 3 CDR FM • AM TAPE 1 • 2
60Hz 500Hz 250Hz 1KHz 2KHz 4KHz 8KHz
VOLUME
SHUFFLE PROGRAM
REPEAT FRONT
DIGITAL SOUND
CONTROL
A. REV
STANDBY
ON
To start the demonstration mode
• Press and hold STOP•CLEAR Ç
(on
the system only) for five seconds when
the system is in standby mode.
™ The demonstration will begin.
Easy Set
EASY SET allows you to store all available
radio stations automatically.
1 Press and hold STANDBY ON (on the
system only) for five seconds; when
the system is in standby or
demonstration mode.
™ “EASY SET” will be displayed,
and followed by “ TUNER” and then
“ AUTO”.
™ EASY SET will start searching for all
radio on FM band and then followed
by radio stations on AM band.
™ All available radio stations with
sufficient signal strength will be
stored. Up to 40 presets may be
stored.
Notes:
– EASY SET will start with the FM band, if
there are still presets available, the
system will continue to store the AM
band.
– When EASY SET is used, all previously
stored radio stations will be replaced.
– The last preset radio station will appear
on the display when EASY SET is
completed.