Pride Mobility JAZZY 1103 - Manual (Page 41)

Jazzy 1103 Rev L/Feb03 www.pridemobility.com 41
Figure 20. Power Seat Switch
POWER SEAT SWITCH
NOTE: Be sure you are on a flat level surface before activating the power elevating seat.
POWER ELEVATING SEAT OPERATION
You can control the power seat through either the toggle switch located on the armrest or your controller. For
information on how to raise and lower your power seat through your controller, see VIII. “Operation.”
n To raise the power elevating seat, push the toggle switch forward. See figure 20. Releasing the toggle
switch returns the switch to its center (upright) position. To continue your lift, push the toggle switch
forward again. Once the seat reaches its highest extension, the lift action stops; you should continue to
hear and/or feel the lift motor running. This is because there is a clutch mechanism that allows the
motor to continue running after the lift has reached its limit. This clutch works at both the top and
bottom extensions of the lift.
WARNING! Do not allow the motor to run more than a few seconds after the mechanism reaches
the top or bottom limit.
n To return the seat to its lowest position, pull the toggle switch toward you. Releasing it stops the motor.
When returning to the lowest position, always be sure that the mechanism has reached its lowest limit.
n To use the swivel feature, locate the swivel lever under the seat. It is located on the opposite side of the
controller. Push down on the lever and the seat can be swiveled 90 degrees.
I X . O P T I O N S A N D A C C E S S O R I E S