Pride Mobility JAZZY 1103 - Manual (Page 22)

22 www.pridemobility.com Jazzy 1103 Rev L/Feb03
V . C O M F O R T A D J U S T M E N T S
FOOTREST HEIGHT
The footrest height is easily adjusted to six different heights.
To raise or lower the footrest:
1. Use a hex key to remove the bolt, spacers, and nut from
the footrest. See figure 12.
2. Raise or lower the footrest to the desired height.
3. Reinstall the bolt, spacers, and nut into the footrest.
FOOTREST ANGLE
You can adjust the angle of the footrest with a hex key. See
figure 13.
To adjust the footrest angle:
1. Turn the setscrew clockwise to raise the front of the
footrest.
2. Turn the setscrew counterclockwise to lower the front of
the footrest.
FOOTREST DEPTH
The Jazzy uses a ball detent pin to fasten the footrest to the
power base. For your convenience, Pride also supplies a hex
head bolt and Nylock nut. You can use this bolt and nut instead
of the ball detent pin, for a more permanent fit.
To adjust the footrest depth:
1. Remove the ball detent pin from the footrest bracket.
2. Move the footrest in or out to the desired depth.
3. Reinstall the ball detent pin or insert the hex head bolt and
nut and tighten.
ARMREST HEIGHT ADJUSTMENT
Your Jazzy may be equipped with armrests that are adjustable
in one-inch increments.
To change the armrest height:
1. Use a hex key to loosen the setscrew.
2. Move the armrest up or down to the desired height.
3. Tighten the setscrew.
FOOTREST ANGLE
ADJUSTMENT
FOOTREST DEPTH ADJUSTMENT
(BALL DETENT PIN SHOWN)
FOOTREST HEIGHT
ADJUSTMENT
Figure 12. Footrest Adjustment
Figure 13. Footrest Adjustment