beautypg.com

Pride Mobility JAZZY 1103 User Manual

Page 21

background image

Jazzy 1103 Rev L/Feb03

www.pridemobility.com

21

TURN THIS HEX SCREW TO CHANGE ARMREST ANGLE.

V . C O M F O R T A D J U S T M E N T S

Figure 11. Wire Tie Location

USE A WIRE TIE TO SUPPORT

THE CONTROLLER CABLE.

ARMREST WIDTH ADJUSTMENT

To change the armrest width:

1. Locate the two knobs on the armrest receiver bracket.

See figure 8.

2. Loosen the knobs; slide the armrests in or out for the desired

width.

3. Retighten the knobs.

ARMREST ANGLE ADJUSTMENT

You can adjust the armrest angle to fit your specific needs.

To change the armrest angle:

1. Lift the armrest straight up so that it is perpendicular to the

floor.

2. Use a wrench to loosen the jam nuts. See figure 9.

3. Use a hex key to loosen the hex screw. Turn the screw

clockwise to raise the front of the armrest and

counterclockwise to lower the front of the armrest.

4. Lock the adjustment screw into place by tightening the jam nuts.

CONTROLLER EXTENSION ADJUSTMENT

The controller can easily slide out away from the armrest, or in

toward the armrest.

To extend the controller:

1. Use a hex key to loosen the setscrew.

2. Slide the controller into or out of the armrest to the desired

position. See figure 10.

3. Retighten the setscrew by turning it clockwise.

CONTROLLER POSITION

You can position the controller for either left-hand or right-hand use.

To change the controller position:

1. Unplug the controller and the charger inhibit connectors from

the electronics tray. See figure 4.

2. Cut the wire tie that attaches the controller cable to the armrest.

See figure 11.

3. Use a hex key to loosen the setscrew. See figure 9.

4. Slide the controller out of the armrest.

5. Loosen the setscrew in the other armrest.

6. Place the controller in the other armrest.

7. Tighten the setscrew.

8. Use a wire tie to secure the controller cable to the armrest.

9. Plug in the controller and the charger inhibit connectors to the

electronics tray.

Figure 10. Controller Extension

LOOSEN THIS

SETSCREW TO

ADJUST

CONTROLLER.

JAM NUTS

LOCK

ADJUSTMENT

SCREW IN

PLACE.

Figure 9. Armrest Angle