Pride Mobility JAZZY 1103 - Manual (Page 20)

20 www.pridemobility.com Jazzy 1103 Rev L/Feb03
After you have become familiar with your Jazzy’s operation, you may find the need to adjust the seat. There are
some adjustments you can make to increase your comfort such as seat height, armrest angle, footrest height and
angle, and joystick position.
WARNING! If your Jazzy was configured at your authorized Pride provider, please consult your
healthcare professional before changing the seat position or making any other adjustment. Some
adjustments may degrade you Jazzy’s performance and safety by changing its center of gravity.
V . C O M F O R T A D J U S T M E N T S
Figure 7. Seat Height Adjustment
SEAT PEDESTAL
Figure 8. Armrest Width
LOOSEN KNOB TO MOVE ARMREST.
SEAT PEDESTAL BOLT
SEAT
POST
HEX
HEAD
BOLT
HEX
HEAD
NUT
You may need the following to make comfort adjustments:
n Metric/Standard Hex Key Set
n Metric/Standard Socket Set and Ratchet
n Adjustable Wrench
SEAT HEIGHT
You can change the seat height to one of three positions in one-
inch increments.
WARNING! Do not pick up the seat frame by the
armrests. They are free to pivot, and you may lose
control of the seat if they do so, resulting in
personal injury or damage to the chair.
To change the seat height:
1. Turn the power off.
2. Make sure the Jazzy is not in freewheel.
3. Unplug the controller and charger inhibit connectors.
4. Pull the seat release lever forward to unlock it.
5 Lift the seat up and out of the seat post.
6. Lift off the shroud.
7. Loosen the seat pedestal bolt. See figure 7.
8. Use two wrenches to loosen and remove the hex head nut and
bolt. See figure 7.
9. Slide the seat post up or down in the seat pedestal.
10. Align the holes on the seat post and the seat pedestal.
11. Reinstall the hex head bolt and tighten.
12. Tighten the seat pedestal bolt.
13. Reinstall the shroud.
14. Reinstall the seat.
15. Reconnect the controller and the charger inhibit.