Polaris Sportsman 9922452 - Manual (Page 43)

39
FEATURES AND CONTROLS
Instrument Cluster
Rider Information Center
3. Speed Display - This area displays vehicle ground speed or engine
rotational speed when the corresponding display is selected. See
page 40.
4. Fuel Gauge - The segments of the fuel gauge show the level of fuel
in the fuel tank. When the last segment clears, a low fuel warning is
activated. All segments including the fuel icon will flash. Refuel
immediately.
Tip: If the fuel icon fails to display, an open or short circuit has occurred in the
fuel sensor circuit. See your dealer.
5. High Beam Indicator - This indicator appears when the lights are
set to high beam.
6. Clock - The clock displays time in a 12-hour or 24-hour format. If
the engine is turned off, press the MODE button. The time will dis-
play for 5-10 seconds. See page 42 for resetting instructions.
7. Engine Overheat Warning - This indicator flashes to indicate an
overheated engine. If the indicator stops flashing but remains illu-
minated, the overheating condition remains, and the system will
automatically reduce engine power.
8. Service Indicator - A flashing wrench symbol alerts the operator
that the preset service interval has been reached. The vehicle should
be brought to your dealer for scheduled maintenance. See page 42
for resetting instructions.
9. Under / Over Voltage - This warning usually indicates that the
ATV is operating at an RPM too low to keep the battery charged. It
may also occur when the engine is at idle and high electrical load
(lights, cooling fan, accessories) is applied. Drive at a higher RPM
or recharge the battery to clear the warning.
10. Check Engine Warning Indicator - This indicator appears if an
EFI-related fault occurs. Do not operate the ATV if this warning
appears. Serious engine damage could result. See your dealer.
11. 4X4 Indicator - This indicator illuminates when the 4X4 system is
engaged (switch is on either ADC 4X4 or 4X4).
12. EPS Warning Indicator - This indicator illuminates when the key
is turned to the ON position and goes off when the engine is started.
If the light remains on after starting the engine, the EPS system is
inoperative. See your authorized Polaris dealer for service.