Panasonic PV-D734S - Manual (Page 33)

33
Stereo recording and playback / Second Audio Program (SAP)
When a MTS STEREO broadcast is
received, the word STEREO will
appear on the screen and the program
can be viewed or recorded in stereo.
The Hi-Fi STEREO recording procedure
is the same as for normal recordings.
The VHS Hi-Fi audio system permits high fidelity recording of MTS
STEREO TV broadcasts.
NOTES:
When playing back a tape that is not
recorded in Hi-Fi stereo mode, the
audio will automatically be monaural.
When listening to a VHS Hi-Fi video
tape or MTS broadcast through the
VHF/UHF jack (Audio/Video cord not
connected), the sound will be
monaural.
Stereo recording and playback
NOTE:
When using a CATV system, stereo TV programs may be transmitted
over a mono cable channel. In this case the word “STEREO” will not
appear and the sound will be in mono.
When viewing an MTS STEREO TV program, or playing a prerecorded
VHS Hi-Fi STEREO videotape, press AUDIO to select how the audio
will be heard through the speakers. Normally set to the Hi-Fi STEREO
position, this button can be set to the MONO position if the stereo
broadcast or videotape audio is of poor quality. The “R” and “L” posi-
tions allow the audio from the Right or Left Hi-Fi channel to be heard
over both TV speakers. This button has no effect when viewing a
MONO videotape or TV program. Each time when you press the button,
OUTPUT SELECTION display appears on the screen for several
seconds. Refer to the chart below.
Output selection
OUTPUT
SELECTION
STEREO
L ch
R ch
MONO
SOUND HEARD ON BOTH
SPEAKERS
STEREO
LEFT CHANNEL AUDIO
RIGHT CHANNEL AUDIO
MONO
Your VCR is fitted with a SAP broadcast system which enables
you to switch to a second audio program when viewing a
selected channel.
This function applies only when the program is broadcast in
multi-languages through the SAP broadcast system.
Second Audio Program (SAP)
Press VCR MENU. Then press SET + or – to select “SAP”.
1
2
Then press ENTER to select “ON”.
Then press VCR MENU until the
menu screen is cleared.
When the VCR is turned on or a channel selection is made, make
certain the letters “SAP” appears on the screen. This means that the
“Second Audio Program” broadcasting is available.
Listening to SAP
OR
•
•
STEREO
STEREO SAP SAP
á+/-/ENTER/MENUñ
MENU
TIMER REC SET
AUTO REPEAT ON OFF
ON OFF SAP
CH SETUP
SYSTEM SETUP
2C51801A (28-33) 19/08/2003, 10:37 33