Access from the camera / system device – Panasonic WV-NP472 User Manual

Page 13

• Function Comparison / PC Network vs. Camera site

-13-

4. Set the following parameters.

Note:

Ask your system administrator about param-

eters if you are unsure.

IP Address:

Enter numbers 0 through 255 into four

sections split by dots.

Netmask:

Enter numbers 0 through 255 into four

sections split by dots.

Default gateway:

Enter numbers 0 through 255

into four sections split by dots

HTTP Port:

Enter different numbers for each when

multiple cameras are connected.

DNS (Domain Name System):

Set to ON when

using DNS. Enter the primary address. If nec-
essary, enter the secondary address.

DHCP (Dynamic Host Configuration Protocol):

When set to ON, you need not input for the IP
address, netmask, and default gateway.

Note:

You can forcibly change the IP address of

the camera as follows, if you have wrongly set
DHCP to ON in the system where no DHCP
server exists.

1. Start up DOS prompt.
2. Execute "arp-s

address>".

3. Execute "ping-t

address>".

• Carry out only when the system has no DHCP

server.

• The new IP address should be within the same

subnet.

• Procedures above will not function when the

system is running normally.

5. Click the SET&REBOOT button. The changed

parameters will be validated, and the camera and
the PC will restart.

Note:

Do not omit the step 4 above to validate new

parameters.

6. Close the browser software, and the PC.

Access from the Camera/System Device

You can operate and set up the camera from such sys-
tem devices as Video Multiplexer, Matrix Switcher, or
system controller if connected.
You can operate and set up at the camera site using
the side panel buttons on the camera while observing
the monitor.

Note:

See the manuals included with the system

devices for operating the camera from them

A: Available, NA: Not Available

Note:

*1 A system device e.g. Video Multiplexer, or a system controller operates the setup menus. Side panel buttons on

the camera can do it as well.

Function

PC Network

Camera Site (*1)

VIEWING IMAGES

Zoom (with Panasonic’s motorized lens)

Focus

Iris (with Panasonic’s ALC lens)

Switching Color/BW Mode

AUX Device Control

Alarm Log/Alarm Image Display

MENU SETUPS

Camera Setup (Camera)

Network Setup (Camera)

Network Setup (HTML)

Operating Mode Setup (HTML)

Alarm Setup (HTML)

FTP Client Setup (HTML)

User Authentication (HTML)

Host Authentication (HTML)

System Setup (HTML)