Philips WP3892 - Manual (Page 7)

4 Preparing for use
We advise you to have the pure water dispenser
installed by trained service technicians.
D Note:
If the water pressure in your area is lower than
the specified minimum pressure (0.5 bar), we
advise you to use a suitable domestic water
pump.
D Note:
If the water pressure in your area is higher than
the specified maximum pressure (2.0 bar), the
use of a pressure reducing valve is required.
4.1 Installation
1
Select a suitable location for the pure water
dispenser.
Install the pure water dispenser at a
convenient and safe location where it
poses no risk of injury.
Install the pure water dispenser 1m away
from the tap.
Install the pure water dispenser
in vertical position. Do not install it at an
angle or in horizontal position.
Only connect the mains plug of the pure
water dispenser to a socket located
higher than the pure water dispenser.
Make sure that the display is at eye level
or slightly above eye level.
2
Drill 3 holes in the wall as shown in picture.
•
•
•
•
•
1m 1m
Quality Association, USA) for products
that meet or exceed industry standards for
contaminant reduction, structural integrity
and material safety.
EN
g
li
sh