Philips WP3892 - Manual (Page 15)

1
3
Turn the filter cap (1) and remove it (2).
4
Grab the handle on top of the filter (1) and
slowly pull the filter out of the holder (2).
5
Put a new filter in the filter holder.
6
Align the arrow on the cap with the arrow
on the filter housing and press the cap down
firmly (1). Turn the cap clockwise to fix it (2).
8
Insert the tube with the rubber ring in the
UV chamber.
D Note:
Make sure you put the rubber ring and
quartz tube in the correct position.
9
To reattach the UV lamp unit, follow steps 6
to 8 in section ‘Replacing the UV lamp unit’.
10
Close the cover of the UV chamber.
7.0.4 Replacing the filter
D Note:
Switch off the pure water dispenser before you
replace the filter.
The filter has a capacity of up to 3000 litres.
When 200 litres have passed through the
filter, the filter indicator c starts flashing to indicate
that you need to replace the filter. At this point,
the appliance can still dispense another 300 litres
of water, giving you time to arrange a new filter.
The filter indicator keeps flashing until 3000 litres
have passed through the filter. Then the filter
indicator lights up red continuously and the pure
water dispenser does not dispense water until you
replace the filter.
D Note:
We advise you to change the filter every
6 months, even though you might not have
consumed 3000 litres. Filter life is subject to the
actual level of impurities in your water supply.
The filter may therefore expire before 3000
litres without any warning period.
1
Switch off the pure water dispenser.
2
Open the appliance door (1). Pull the filter
towards you with the lever (2) and slightly
tilt the filter.
EN
g
li
sh