Philips WP3892 - Manual (Page 14)

1
7.0.3 Cleaning the quartz tube
We advise you to clean the quartz tube once
every months.
B Warning:
Handle the quartz tube with care, as it might
break and cause injury. Do not tamper with the
quartz tube (apply glue, etc.).
1
Switch off the pure water dispenser.
2
Open the cover of the UV chamber.
3
To remove the UV lamp unit, follow steps 1
to 5 in section ‘Replacing the UV lamp unit’.
4
Pull out the quartz tube with the rubber
ring.
5
Remove the rubber ring.
6
Clean the quartz tube with a clean moist
cloth and dry it completely.
7
Reinsert the rubber ring to a depth of 2-
3mm from the open end.
7 Cleaning and
maintenance
7.0.1 Cleaning the pure water dispenser
B Warning:
Never use scouring pads, abrasive cleaning
agents or aggressive liquids such as petrol or
acetone to clean the appliance.
B Warning:
Do not pour water over the pure water
dispenser.
1
Clean the outside of the pure water
dispenser regularly with a damp (not wet)
cloth.
2
If you have not used the appliance for 2 days
or more, perform the PureFlush procedure
(see chapter ‘Using the appliance’, section
‘PureFlush’).
7.0.2 Cleaning the macro filter
1
Switch off the pure water dispenser.
2
Turn off the water supply to the pure water
dispenser.
3
Unscrew the water inlet connector (hold it
in vertical position to avoid water spillage)
and pull out the macro filter.
4
Rinse the macro filter under a running tap.
Remove the dirt from the mesh.
5
Put the macro filter back in its original
position.
6
Reattach the water inlet connector.