Philips TP3684C1 - Manual (Page 38)

38
SLEEP POWER
AV ON/OFF POSITION FREEZE TV
VCR
ACC
SWAP SOURCE PIP CH
UP DN
SMART
SOUND
SMART
PICTURE
MENU SURF
VOL CH
MUTE
CC STATUS CLOCK A/CH
EXIT TV/VCR
RECORD MEDIA
INCREDIBLE
VCR MULTI
06
07
08
09
06
07
08
09
1
3
4
3
07
08
09
2
S
ETTING THE
R
EMOTE
C
ONTROL
T
O
O
PERATE
A
CCESSORY
D
EVICES
Y our TV remote can be set to
work various accessory
devices such as VCRs, Cable
Boxes, Satellite Receivers, DBS,
DVD, etc. by using the search
method.
If the Direct Access method
shown on page 37 did not set
your remote to work your acces-
sory device, follow the easy steps
listed below.
Please read steps 1-4 before
beginning.
Turn ON the device by press-
ing the POWER button on the
device you are attempting to pro-
gram.
Place the TV/VCR/ACC
Mode Switch in the proper posi-
tion.
Press and hold the VCR
RECORD and the SMART
SOUND buttons simultaneous-
ly.
The device will begin to
change channels after the remote
identifies the correct code. When
the channels start to change,
release the VCR RECORD and
SMART SOUND buttons. The
remote should be ready to oper-
ate the device.
Cable Converter
S
MART
H
ELP
This method can take up to
two minutes to perform.
Don’t let the device change more
than five channels after the remote
identifies the code. If you do, the
remote may pass up the right code;
another two minute search cycle will
have to be repeated.
If no channel change happens within
two minutes, repeat steps 1-4.
Should a channel change still not
occur, the remote will not work the
desired device.
BEGIN
Satellite Receiver,
DBS, DVD,
or similar device
VCR
Search Method