Perle Systems P840 - Manual (Page 26)

Event Logs
26
LCP X authenticating peer with PAP
Generated when this device is using PAP to authenticate the peer (remote) device.
LCP X establishing
Generated when the Link Control Protocol of a PPP link or remote site is establishing between this device
and the remote site PPP device.
LCP X no reply to Y Echo-Requests
Generated just prior to a link going down. The link or remote site has gone down due to no replies to the
echo request messages sent.
LCP X operational
Generated when the Link Control Protocol of a PPP link or remote site has been negotiated and is now
operational between this device and the remote site PPP device.
LCP X peer authenticating with CHAP
Generated when the peer (remote) device is using CHAP to authenticate this device.
LCP X peer authenticating with PAP
Generated when the peer (remote) device is using PAP to authenticate this device.
LCP X received Protocol-Reject for
Generated when the peer (remote) device rejects one of the Network Control Protocols.
No NCP's open, tearing link down
Generated when a PPP link does not have a Network Control Protocol operating. This may be due to BCP,
IPCP, and IPXCP being disabled, or the NCP connection was not negotiated to completion.
Password accepted from
Generated when a correct password is given for a Telnet connection. The connected Bridge/Router’s name
or IP address is specified.
Refused connection attempt from
Generated when a connection attempt to a remote site is refused by that site
Remote Site re-establishing due to multilink mismatch
Generated when multilink negotiated on by one end of the link and off by the other. The value for multilink
will be toggled on this device and LCP will be re-negotiated.
Remote Site starting callback
Generated when an incoming CallID was matched to a remote site, and that remote site was configured for callback.
The incoming call will be rejected, and an outgoing callback to the remote site will be attempted.