Event logs – Perle Systems P840 User Manual
Page 24
Event Logs
24
Completed BCP negotiation with
Generated when the Bridging Control Protocol negotiation has been completed with the remote site device
associated with the stated remote site profile. Once BCP negotiations are complete, IP routing may take
place between the two routers.
Completed CCP negotiation with
Generated when the Compression Control Protocol negotiation has been completed with the remote site device
associated with the stated remote site profile. Once CCP negotiations are complete, IP routing may take place
between the two routers.
Completed CMCP negotiation with
Generated when the Connection Management Control Protocol negotiation has been completed with the
remote site device associated with the stated remote site profile. Once IPCP negotiations are complete, IP
routing may take place between the two routers.
Completed IPCP negotiation with
Generated when the Internet Protocol Control Protocol negotiation has been completed with the remote site
device associated with the stated remote site profile. Once IPCP negotiations are complete, IP routing may
take place between the two routers.
Configuration restored
Generated during a warm start when a configuration is successfully restored from non-volatile RAM.
Connection attempt to
Generated when the bridge/router attempts a Telnet connection. The IP address of the target bridge/router is
specified.
DHCP: pool deleted due to mismatch with new IP address
Generated when the address of this device is changed , rendering the block of addresses assigned to the DHCP pool
invalid.
DHCP: Requested address unavailable
Generated when the address requested by a client is unavailable
DHCP services – declined. Address
Generated when a client declines an address offered by the DHCP service, usually because the client has found from
some other source that the address is unavailable.
DHCP services – release.
Generated when IP address displayed is released from its assignment to a device and put back in the IP pool for re-
assignment.
Error executing: XXXXXX
Generated when an error is detected loading back a configuration. The invalid command is specified.
Idle timeout expired, disconected