Philips - DCM278 - Manual (Page 12)

12
Auto install radio stations
When you connect power and no radio
stations are stored, the unit automatically begins
to store radio stations.
1
Connect the unit to the power supply.
[
» AUTO INSTALL - PRESS PLAY
KEY](auto install - press play key) is
displayed.
2
Press on the main unit to start
installation.
The unit automatically stores radio
»
stations with sufficient signal strength.
When all the available radio stations
»
are stored, the first preset radio station
is broadcast automatically.
Set clock
Note
You can set the clock in the standby mode •
only.
1
Press PROG/CLOCK SET to enter the
clock setting mode.
[
» SET CLOCK](set clock) scrolls on the
screen.
2
Press / repeatedly to select 12 hour
or 24 hour format.
3
Press PROG/CLOCK SET to confirm.
The hour digits are displayed and begin
»
to blink.
4
Press / to set the hour.
5
Press PROG/CLOCK SET to confirm.
The minute digits are displayed and
»
begin to blink.
6
Press / to set the minute.
7
Press PROG/CLOCK SET to confirm the
clock setting.
1
Open the battery compartment.
2
Insert 2 AAA batteries with correct
polarity (+/-) as indicated.
3
Close the battery compartment.
Note
If you are not going to use the remote control •
for a long time, remove the batteries.
Do not use old and new or different types of
•
batteries in combination.
Batteries contain chemical substances, so they
•
should be disposed of properly.
Connect power
Caution
Risk of product damage! Ensure that the •
power supply voltage corresponds to the
voltage printed on the bottom of the unit.
Before connecting the AC cord, ensure you
•
have completed all other connections.
Note
The type plate is located on the rear of the •
main unit.
1
Connect the AC cord to the AC outlet.
EN