2 mounting installation, 1 din-rail mounting – Planet Technology ISW-800M User Manual

Page 14

Fault Alarm Contact

24V DC Buzzer

24V Battery

The open circuit will form

when the power failure or

port link failure.

The fault alarm device will

send a warning signal t

warn the user, ex: alarm

sound or flash light.

2.2 Mounting Installation

This section describes how to install the Ethernet Switch and make connections to it. Please read the

following topics and perform the procedures in the order being presented.

2.2.1 DIN-Rail mounting

The DIN-Rail is screwed on the industrial switch when out of factory. If the DIN-Rail is not screwed on the

industrial switch, please see the following figure to screw the DIN-Rail on the switch. To hang the

industrial switch, follow the below steps:

Step1:

Insert the top of DIN-Rail into the track.