Porter-Cable PC305TP - Manual (Page 8)

8
KNIFE TRANSFER TOOL STORAgE
The knife transfer tool (A) Fig. 15, supplied with your planer,
can easily be stored underneath the outfeed table extension
(B) when not being used. A Velcro strip (C) is provided on the
tool and underneath the table for this purpose.
WRENCH STORAgE
The wrench (A) Fig. 16, can be stored in hole (B) located on the
right rear side of the machine as shown.
CARRYINg HANdLE/STOCK TRANSFER BAR
1. Your planer is provided with a foam covered carrying
handle (A) Fig. 17, located on top of the machine, for ease
in transporting the planer.
2. The carrying handle (A) Fig. 18, also doubles as a stock
transfer bar for transferring stock from the outfeed to
infeed end of the machine. This is helpful when planing
long material, as the workpiece can easily be transferred
back to the infeed end of the machine for additional cuts.
REPLACINg KNIVES
The knives supplied with your planer are double edged and
reversible, which enables you to turn the knives end-for-end
when one edge becomes dull or chipped. To change the
knives, proceed as follows:
C
B
A
C
A
B
15
16
A
B A
A
disconnect tool from power source.
1. Raise head assembly all the way to the top.
2. Remove cutterhead guard (B) Fig. 19 by removing two
knobs, one of which is shown at (A).
The knives are extremely sharp. Be careful
when removing, handling or installing knives.
3. Using the supplied wrench (E) Fig. 20, unscrew the six
screws at (F), only enough until locking bar (D) separates
from knife, allowing knife to be removed.
17
18
19
F F
E
D
20
J
G H
21