Panasonic C9700U - Manual (Page 29)

68
CQ-C9800/9700U CQ-C9800/9700U
69
Installation Guide
(continued)
8 Lock cancel plate
Remove the Unit
Switch off the power of the unit.
1 Remove the removable face plate (page 63).
2 Remove the trim plate 7 with a screwdriver.
3 1 Insert the lock cancel plates 8 along the
grooves on both sides of the main unit
until “click” is heard.
2 Pull out the unit while pushing the plates
further inside.
4 Remove the unit pulling with both hands.
7 Trim plate
1 Insert.
Insert the tab
end in the
outer groove.
Screwdriver
2 Pull out.
“Click”
E
N
G
L
I
S
H
49
E
N
G
L
I
S
H
50
Installation Procedures
The included mounting collar 1 is designed
specifi cally for this unit. Do not use it to attach
any other model.
6 Power
connector
Engage the mounting
springs (
§) in the
mounting holes of the
mounting collar
1
fi rmly.
The tabs to be bent vary depending on
the car. To securely install the unit, fully
bend a number of the tabs so that there is
no rattling.
(b) Using the rubber cushion (option)
1 Insert mounting collar 1 into the
dashboard, and bend the mounting tabs out
with a screwdriver.
2 Secure the rear of the unit.
After fi xing mounting bolt
5 and power
connector 6, fi x the rear of the unit to the
car body by either method (a) or (b) shown
below.
3 Insert trim plate 7.
4 After installation,
reconnect the
negative
- battery
terminal.
Mounting holes
Mounting
springs (
§)
5 Mounting bolt
Mounting springs ( §)
Mounting
hole
(a) Using the rear support strap 3
4 Tapping screw
Fire wall of car
2 Hex. nut
3 mm ‡
3 Rear support strap
5 Mounting bolt
1 Mounting collar
Rubber cushion (option)
Rear support bracket
(provided on the car)
5 Mounting bolt
1 Mounting collar
Tab
First complete the electrical connections, and then
check them for correctness (page 70).
Example:
Remove the
mounting collar
1
and the trim plate 7
from the main unit
temporarily, which
are already mounted
at shipment.