Panasonic P2HD AG-HPG20P - Manual (Page 82)

Screen displays (continued)
: Normal playback
: Playback pause
REPEAT : Repeat playback
1CLIP : Single clip playback
1CLIP R : Single clip repeat playback
( ) :
Rapid forward playback (rapid reverse playback)
( ):
Forward frame feed playback (reverse frame
feed playback)
x /x (x /x ):
Forward variable-speed playback (reverse
variable-speed playback)
CLIP (CLIP ):
Forward clip feed (reverse clip feed)
15 HDD easy playback display
This is displayed during easy playback from
the hard drive. When playback performance
deteriorates, the display blinks for 3 minutes.
When the hard drive is damaged or vibrations
are added to the hard drive, the display may
become incorrect.
16 Repeat playback setting display
This appears when “ON” has been selected for
the “REPEAT PLAY” item on the setting menu
“PLAYBACK FUNCTIONS”.
1 Remaining battery charge display
As the remaining charge drops, the display
changes in the following sequence:
and .
When the charge is low, “LOW BATTERY”
appears on the LCD monitor.
(While the AC adapter is being used, a display
other than
may appear: this is normal
and is not a sign of trouble.)
1 Media information displays
The card slots in which P2 cards have been
inserted and the basic information on the cards
are displayed.
1 2 Lighted:
Recordable P2 card
1 2 Lighted in green:
P2 card targeted for recording
1 2 Blinking:
Card recognition underway
:
No card inserted
P : Write-protected card
F : No memory remaining
X : Card cannot be recognized
E : Improperly formatted P2 card (which can be
used if it is formatted properly)
1 Remaining media memory displays
The amount of memory remaining on the
card in the slot targeted for recording is
displayed when “ONE CARD” is selected for
the “P2CARD REMAIN” item on the setting
menu “DISPLAY SETUP”. The target slot
can be switched to another slot using “SLOT
SEL” assigned to [USER]. When “TOTAL” is
selected, the total amount of memory remaining
on the two cards is displayed.
0 Monitor volume level meter
When is pressed, the level of the
volume which is output from the speaker and
headphone jack is displayed.
You can adjust the volume level using the
and buttons.
During variable-speed playback, while holding
down [ALT/3], press and button to adjust
the volume.
Major warning displays
This section provides major warning displays
which are displayed on the LCD monitor. For other
warning displays, check the displayed messages.
C
CANNOT ACCESS!
Data cannot be accessed because of a
problem in the content or for some other
reason. Restore the media or clips to the
normal operating status, and then use the
data.
CANNOT ACCESS CARD!
An error occurred while accessing the P2
card. Check the P2 card.
CANNOT ACCESS TARGET!
An error occurred while accessing the
connection destination target. Check the
hard drive status and connections.
CANNOT DELETE!
Data cannot be deleted because of a
mismatch in the content versions. Ensure
that the same content version as the device
is used.
CANNOT FORMAT!
The P2 card cannot be formatted because of
a problem. Check the P2 card.
■