Primera Technology LABEL DISPENSER DX850 - Manual (Page 9)

DX850 Label Dispenser 9
To dispense a label, first load label stock as described in Section 2, connect power and switch on
the Label Dispenser. Follow these steps to dispense labels.
1. Before you start dispensing you should adjust the Label Sensor on the Label Sensor Bracket
so that the distance between the Label Sensor and the Peel Edge is equal to roughly 1/2”
less than the label height. (Figure 3-1.)
For example, for a 4" wide x 2" high (101.6mm x 50.8mm) label you would set this distance
to approximately 1-1/2” (38.1 mm). The exact distance is not critical. It is only important
that you set the distance so that the label does not come off the liner when presented. If the
label height dictates the sensor be moved beyond the available travel, set the sensor to the
minimum or maximum position as applicable.
2. To Start dispensing press the Start/Stop button on the Control Panel. (Figure 3-2.)
Section 3: Dispensing the Label
Figure 3-1.
Counter
Reset +
-
Start/
Stop
Figure 3-2.
1/2" less than Label Height