Primera Technology Accent II 510893-021505 User Manual

Quick start

Quick Start

P/N 510893-021505

Disc Hub Spacer

Disc Present
Sensor

Hub is even with
disc surface

Sensor

Hub is
recessed to
disc surface

Sensor

With the Disc Tray Hub in this
position, laminate will be
transferred to the hub of the
disc.

Disc Surface

Adjusting the Center Hub

1. If the laminate is not adhering to the

hub in the same manner as the rest

of the disc, you may wish to avoid

laminating the center hub. To do this,

lift the Tray Disc Hub Spacer from the

center of the Disc Tray and rotate it

slightly clockwise. Place it back into

the center of the Disc Tray making

certain it seats properly in the tray.

2. Repeat the test with another disc.

When you are satisfied with the

setting, you may want to make a note

of them for future reference. You are

now ready to laminate your discs.

IMPORTANT:

Due to the wide variety of media you may need to adjust the heat setting of your laminator to get the

best transfer. If the laminate is not fully transferring to the disc, the heat must be increased. However,

if the heat is set too high, the printed image on the disc may be distorted. Excessive heat may

even cause the label side to peel off of the disc. Because of this you should use the least amount of

heat necessary to transfer the laminate film to the surface of your disc.

With the Disc Tray Hub in
this position, laminate will
NOT be transferred to the
hub of the disc.

Automated Optical Disc

Duplication & Printing System

DISC PUBLISHER

CD/DVD Optical

Disc Laminator