Primera Technology LABEL DISPENSER DX850 - Manual (Page 3)

Thank you for purchasing the DX850 Label Dispenser (hereafter referred to as "Label
Dispenser").
The Label Dispenser includes a Power Cord, 12 volt Power Adapter and the parts shown in
Figure 1-1. The Roll Bar, Roll Guides and Roll Drag Arm are located in the supply box along
with the Power Cord. You will need to assemble them as shown in Figure 1-1 and 1-2. Also see
Section 2 for more detailed instructions on assembling these parts. Attach the Power Cord
and switch on the power as shown in Figure 1-2. Finally, remove the foam insert between the
Liner Idler Roller and Liner Drive Roller.
Section 1: Unpacking and Setup
Figure 1-2.
Figure 1-1.
Roll Bar
Roll Guides
Label Sensor Bracket
Label Sensor Guide Roller
Liner Drive Roller
Control Panel
Power Switch
Power Input 12V
Roll Bar
Roll Guides
DX850 Label Dispenser 3
Power Adapter
Roll Drag Arm
Liner Idler Roller
Peel Edge
Liner Idler Roller Tab
Power Adapter
Power Cord