Primera Technology LABEL DISPENSER DX850 - Manual (Page 13)

DX850 Label Dispenser 13
Troubleshooting
Motor stalling on labels 6" (152 mm) or wider.
For label stock 6” (152 mm) and wider, it may be necessary to reduce the speed of the Label
Dispenser. The Label Dispenser includes a Half-Speed Mode that generates more power
from the motor for wider label stock. To activate this mode, hold down the - Button while
switching on the unit. The Label Dispenser will revert back to the Default Mode when
switched on without holding down the - Button.
Maintenance
Unclamp Liner Idler Roller.
When not in use, leave the Liner Idler Roller in the unclamped position. This will minimize
the possibility that permanent indentations will be made in the Liner Drive Roller.
Lubricate bearings.
Primera recommends oiling the four bearings associated with the Liner Drive Roller and
Liner Idler Roller. Oil these four bearings for every 50,000 labels dispensed. They should
only be oiled after the first 50,000 labels as they are lubricated with a special grease at the
factory. One drop of any machine oil or motor oil for each bearing should be adequate. This
maintenance is optional but will increase the life of the Label Dispenser for heavy users who
use the Label Dispenser for several hours each day.
Section 6: Troubleshooting and Maintenance