Pioneer AVH-P7550DVD - Manual (Page 91)

Understanding auto TA and EQ error messages
When correct measurement of car interior acoustic characteristics is not possible using the auto
TA and EQ, an error message may appear on the display. If an error message appears on the dis-
play refer to the table below to see what the problem is and the suggested method of correcting
the problem. After checking, try again.
Message Cause Action
Error check MIC Microphone is not connected. Plug the supplied microphone securely into
the jack.
Error check front SP, Error
check FL SP, Error check FR SP,
Error check center SP, Error
check RL SP, Error check RR SP,
Error check subwoofer
The microphone cannot pick up the
measuring tone of any speaker.
! Confirm that the speakers are connected
correctly.
! Correct the input level setting of the power
amp connected to the speakers.
! Set the microphone correctly.
Error check noise The surrounding noise level is too
high.
! Stop your car in a place that is as quite as
possible, and switch off the engine, air condi-
tioner or heater.
! Set the microphone correctly.
AdditionalInformation
En
91
Appendix
AdditionalInformation