beautypg.com

Test tone 71, Selecting a cut-off frequency, Adjusting the speaker output levels – Pioneer AVH-P7550DVD User Manual

Page 71: Audio adjustments

background image

Selecting a cut-off frequency

You can select a frequency, under which

sounds are reproduced through the subwoo-

fer. If the installed speakers include one whose

size has been set to SMALL, you can select a

frequency, under which sounds are repro-

duced through a LARGE speaker or subwoo-

fer.

1 Touch A.MENU and AUDIO and then

touch Sound Setting.

2 Touch Cross Over.

3 Touch the speaker to be adjusted.

# You cannot select speakers whose size is set
OFF.

4 Touch a or b to select cut-off fre-

quency.

Each time you touch a or b selects cut-off fre-

quencies in the following order:

6380100125160200 (Hz)

Note

Selecting cut-off frequencies are to set cut-off fre-
quencies of the subwoofers L.P.F. (low-pass filter)
and that of the SMALL speaker H.P.F. (high-pass
filter). The cut-off frequency setting has no effect
if the subwoofer is set to OFF and other speakers
are set to LARGE or OFF.

Adjusting the speaker

output levels

You can readjust the speaker output levels

using a test tone while listening to music.

1 Touch A.MENU and AUDIO and then

touch Sound Setting.

2 Touch SP LEVEL.

3 Touch the speaker to be adjusted.

# You cannot select speakers whose size is set
OFF.

4 Touch a or b to adjust the speaker out-

put level.

Each time you touch a or b increases or de-

creases the speaker output level. +10 10 is

displayed as the level is increased or de-

creased.

Note

To adjust the speaker output levels at this mode is
the same as making the speaker output levels at
Test Tone. Both provide the same results.

Adjusting the speaker output

levels using a test tone

A convenient test tone allows you to easily get

the overall balance right among the speakers.

1 Touch A.MENU and AUDIO and then

touch Sound Setting.

2 Touch Test Tone.

The test tone is output. It rotates from speaker

to speaker in the following sequence at inter-

vals of about two seconds. The current set-

tings for the speaker over which you hear the

test tone are shown in the display.

Front speaker leftCenter speakerFront

speaker rightRear speaker rightRear

speaker leftSubwoofer

Check each speaker output level. If no adjust-

ments are needed, perform step 4 to stop the

test tone.

# The settings do not appear for speakers
whose size is set OFF.

Audio Adjustments

En

71

Section

14

Audio

Adjustments