Quick guide – Panasonic AG-EZ50UP User Manual
Page 7
7
Quick Guide
1
Charge the Battery.
(
l 12)
≥Connect the AC Cable to the AC Adaptor and AC Jack.
≥Attach the Battery to the AC Adaptor. (This will start the charging
process.)
≥When the Charge Lamp [CHARGE] goes off, the Battery is fully
charged.
≥Since the Battery will not be charged when the DC Cable is connected
to the AC Adaptor, disconnect it.
2
Attach the Charged Battery to the Camera/Recorder.
(
l 12)
≥Attach the battery after tilting the Viewfinder upward.
3
Turn the Camera/Recorder on.
(
l 14)
≥Slide the
1
Switch to [ON]. (The [CAMERA] Lamp lights up.)
4
Insert the Cassette.
(
l 13)
≥Slide the
2
Lever to the right and pull down to open the Cassette
compartment cover.
≥Insert the Cassette.
≥Press the [PUSH/TO CLOSE]
3
to load the Cassette.
≥Close the lower compartment Cover.
5
Start recording.
(
l 20)
≥Press the
4
Button. (Recording starts.)
≥Press the
4
Button again to pause the recording.
To watch the Playback Picture
6
Switch to the VCR Mode, rewind the tape, and play the tape
back.
(
l 28)
≥Slide the
5
Switch. (The [VCR] Lamp lights up.)
≥Press the
6
Button.
≥Press the
7
Button. (This will start playback.)
7
Turn the Camera/Recorder off.
(
l 14
)
≥Set the
8
Switch to [OFF].
SEARCH
BACK
LIGHT
4
CAMERA
CARD P.B.
VCR
2
4
5
1
CAMERA
CARD P.B.
VCR
8
CAMERA
CARD P.B.
VCR
MODE
ON
OFF
POWER
5
CAMERA
CARD P.B.
VCR
MODE
ON
OFF
POWER
OPEN / EJECT
2
7
6
3
6
PUSH
TO CLOSE
3
1
MODE
ON
OFF
POWER
MODE
ON
OFF
POWER
7