Panasonic KX-FM255 - Manual (Page 103)

103
Operations
H
e
lp
For Assistance, Call 1-800-435-7329
Problem Cause & Remedy
¡ “Panasonic MFC Print” was not selected as your printer. Select it.
¡ The print manager of Windows 3.1 was not used. Test using
Notepad in Windows 3.1 or Wordpad in Windows 95.
¡ Another device is in use. Check the outbox, then wait until the
other device is finished or cancel it.
¡ The com port was set improperly. Check the properties and set the
com port with “Test” again.
¡ The com port is competing with the mouse or network card, or uses
the same IRQ as MFC-Print. Change the IRQ setting (refer to your
Windows user manual).
¡ The performance of your PC is not sufficient. At least, CPU386 (DX
33MHz) and 4M RAM are necessary.
¡ An OS (Macintosh, DOS, Win NT, etc.) which the Multi-Function
Center does not support was used. Use Windows 95 or
Windows 3.1/3.11.
¡ All com ports are in use. Assign a com port for the Multi-Function
Center.
¡ The Inbox was set to pause. Remove the check mark from the
Pause Inbox in the Message Center window.
¡ The PC link feature (#14) of the facsimile unit is set to OFF. Set to
ON (see page 93).
¡ The Message Center is not running. Open it.
¡ The Inbox was not set to pause. Set the Inbox to pause or close
the Message Center.
¡ The Message Center is running. Remove the check mark on the
Load in Message Center with Windows property.
¡ Select Automatically Print Incoming Faxes in the Receive dialog
box of the Inbox properties.
¡ Set the desired printer as default in the Print Settings box, or select
the desired printer in the Print dialog box.
¡ See the Viewer instructions in the operating instructions or help list.
¡ There is not enough hard disk capacity. Delete unnecessary
applications or data.
¡ The MFC scan program was activated when other applications
were running and the swap file was full. Check the swap file size
and extend the swap file.
¡ The MFC scan program was activated and there is not enough
RAM capacity. Close the applications in progress.
¡ Try cold reboot.
¡ The receiving unit is busy. Check the outbox and error status log.
¡ The MFC is installed incorrectly. Install it again.
¡ There is not enough RAM capacity. Try again after closing other
applications.
¡ A different fax software was used instead of the Multi-Function
Center.
The facsimile unit cannot print
documents from your PC.
The facsimile unit cannot print the
documents received on your PC.
Documents are received by the
facsimile unit but I want to receive
them on the PC.
Documents are received on the PC
but I want to receive them on the
facsimile unit.
I want to print a received fax with the
pre-selected printer.
I want a received fax to be printed by
another printer.
Documents cannot be scanned on
the PC.
Documents cannot be sent by the
PC.
Multi-Function Center