Planar VS15XAD - Manual (Page 20)

Operations Manual (OM705-00) 16
On-Screen Display Lockout
OSD Lock
The monitor incorporates an OSD lockout function. Pressing the three controls
Function select down , Adjust , Adjust [Buttons 2, 3, 4]
simultaneously will lock out the OSD. Monitor settings cannot be altered at this
point, but navigation through the OSD menus is possible. An “OSD” lock is
displayed at the bottom of the OSD menu. To unlock the OSD, press the same
three controls in the same manner as locking the OSD.
DDC Change (Analog Mode to Digital Mode or Digital Mode to
Analog Mode)
The monitor can be changed from Analog Mode to Digital mode or from Digital
Mode to Analog Mode as follows:
1. Ensure monitor power is “on” (steady or blinking power LED below OSD
buttons).
2. Disconnect video cable from the monitor. The display will indicate “No
video”
3. Wait for the “no video” message to disappear.
4. Push the and buttons simultaneously. This creates a change in the
DDC file and one of the following messages should appear.
The message on the left indicates a change from Analog to Digital mode. The
message on the right indicates a change from Digital to Analog mode.
5. Plug the video cable into the monitor. The monitor should be displaying the
supplied video input.