Using predefined defaults, Us ing pre de fine d de fa ults, D0ee – PSC PT2000TM User Manual

Page 73: D1ee, D2ee

Using Predefined Defaults

User’s Guide

Using Predefined Defaults

Top Gun and the PT2000 have the following three sets of parameter
defaults:

Predefined Default 0 (D0) :

turns every on/off parameter off and sets

all minimum and maximum lengths to zero.

Predefined Default 1 (D1):

turns every on/off parameter on, sets all

minimum lengths as low as possible, and sets all maximum lengths as
high as possible.

Predefined Default 2 (D2) :

is the default set that was installed in the

portable at the factory. This default set will work for most applications.

Reset the portable to a predefined default set by scanning one of the
following bar codes:

Note:

To restore the default settings for serial communications,
scan Serial Communications Parameter (default) bar code
on

*$+$-D0EE*

*$+$-D1EE*

*$+$-D2EE*