Peripheral Electronics Aux2Car - Manual (Page 6)

VEHICLE INSTALLATION
Acura
Before connecting any cables to the Aux2Car you must set the dip switches to the Aux2Car Aux2Car
correct position. If you set the dip-switches after you have connected cables to the
interface, you must disconnect and reconnect them for the Aux2Car to operate. Aux2Car Aux2Car
DIP SWITCHES MUST BE SET BEFORE YOU PLUG IN THE Aux2Car !!! Aux2Car Aux2Car
SETTINGS FOR
ALL ACURAS
1 2 3 4 5 6 7 8
on off off on off off off on
• All Models (1992-2002) – Connector behind the radio, use the
PX HCH2 cable and the Aux2Car settings above. Aux2Car Aux2Car
• TL 1999 to 2002 use Honda cable behind the radio
• Acura NSX, SLX, and MDX (1996 and Up) – Not Compatible.
• Acura’s with navigation are not compatible.
OPERATION
Switch to the Aux2Car adaptor by pressing the CD button on the radio. This step may take Aux2Car Aux2Car
up to three minutes for the radio to initialize. Some radio models require pressing “Seek >”
once to start playing the auxillary source.
4