Peripheral Electronics Aux2Car - Manual (Page 17)

TROUBLE SHOOTING
CHAPTER
3
Symptom Cause Remedy
No Power Blown fuse Replace fuse with same
amp. Rating. If the fuse
blows again, call tech
support.
No Power Bad connection Check cable connection.
Alternator noise is heard
(Changes with gas)
Wrong wiring creates
ground loop.
Call tech support or ask a
local car audio shop.
Radio can’t recognize
Aux2car adaptor
Bad cables or cables are
not connected properly
between converter box and
car radio
Check connection and
cables, push in fi rmly.
Aux2car adaptor suddenly is
not recognized any more
Bad connection or loss of
power to interface
Unplug the black converter
box from Radio and plug
again
Radio can’t recognize
Aux2car adaptor
Wrong selection on dip
switch in the converter box
Select the right protocol for
you car. (See Page 3)
For technical support call 800-477-2267 9:30 am-6pm EST. MON - FRI
15